Porta-Nail 421P Pneumatic Floor Nailer with Both Line Nailer Shoe and Face Nailer Shoe by Porta-Nails

• Pneumatic floor nailer; easily adapts from line nailer shoe to floor nailer shoe; mallet activated
• 4-1/2 cfm at 90 psi; oil-less system; holds up to 200 nails
• Die-cast aluminum body
• Includes nailer, mallet, face nail shoe, instructional DVD, safety glasses, carry case
• 26.8 by 5.5 by 20.2 inches; 17 pounds; 1-year limited warranty

Preferred seating system; Designed for nailing 1/2" - 33/32" flooring; Set up for 3/4" only; Pneumatic version of PNI's original Hammerhead; Easily converts to a face nailer by simply changing the shoe; Mallet activated to ensure the tightest floor possible; Ruggedly built to provide durability throughout years of use; Holds up to 150 2" T Porta-Nails; Both angle and face nails; Air Filtration; Two year limited warranty; Requires 4.6 CFM @100PSI for optimum performance; Includes carrying case; Safety: 1) prevent accidental firing 2) can impact the tool without firing to draw flooring boards tight
If you invented the perfect hardwood flooring nailer, you'd make one tool for both face and tongue nailing, pneumatic power, superior fasteners, a generous magazine and flexibility for different flooring thicknesses.

Porta-Nails beat you to it. With a simple hardware change (two nuts and a screw), the 421P becomes a face nailer or angle nailer, saving you time and exertion on those first and last few rows of face-nailed flooring and speeding you through the rest of the installation. Connected to a compressor, the 421P needed only a squeeze of the safety trigger and light mallet blow to pneumatically drive the 2-inch serrated nails through the tongue and into the subfloor. Porta-Nails' exclusive "ratcheting ram" doesn't return to the start position until the fastener is properly seated, so you know every nail you drive is doing its job. You'll want to adjust your pressure to get just the right countersink before going ahead with your project, but be sure not to exceed 110 psi.

If the nailer should jam, clearing is quick and easy, because you don't have to remove the shoe to open the latch clip. Fasteners load easily, and the magazine holds 200 2-inch nails, so you spend more time installing and less time reloading. We liked the fact that the shoe bases are all non-marring, and the rubber mallet is capped, too, to prevent marking your flooring.

There's really only one mistake you can make with this nailer, and that's to work too hard. You'll be tempted as we were to grip the nailer tightly and really give it a good hit, but trust us: You'll get far better results by relaxing your stance and delivering a comfortable blow to the ram.

It's easy enough for the first-time home do-it-yourselfer to install a floor and save a bundle on labor costs, and the professional will use it on every hardwood installation job. Definitely worth the investment.--Kris Jensen-Van Heste